Table of Contents
Advertisement
Figure 4
2. Installing the Wheel Clutch
Cable Ends
1. Unwrap the cable ends from the lower handle (Figure 5).
Figure 5
2. Route either the left or right cable end over the lower
handle and insert the cable end into the hole in the
corresponding wheel clutch lever (Figure 6).
Figure 6
1. Wheel clutch lever
3. Remove the nut and washer from the handle, attach
the cable clamp on the cable to the handle, insert the
washer, and hand tighten the nut (Figure 7).
Figure 7
1. Cable clamp
Important: Ensure that the curved side of the
cable clamp is against the handle and that the cable
is routed below the clamp bolt. The cable must be
in a straight line from the cable clamp to the point
where it attaches to the wheel clutch lever.
4. Pull the cable jacket down gently until the wheel clutch
lever is down and the slack is out of the cable, then
tighten the cable clamp nut securely (Figure 8).
Figure 8
5. Squeeze the lever fully, then check the gap between
the bottom of the handle and the wheel clutch lever
end (Figure 9).
Figure 9
Note: The gap should be approximately the thickness
of a pencil (1/4 inch or 6 mm). If it is greater, loosen
the cable clamp nut, slide the cable jacket up slightly,
tighten the cable clamp nut, and check the gap again.
6. Repeat steps 2 through 5 for the other cable.
7
Advertisement
Table of Contents
