Philips PET100 Service Manual page 2

1.0 TECHNICAL SPECIFICATION
General
Dimensions (W x H x D):
Weight:
Power supply:
Power consumption:
Operating temp. & RH:
Laser wavelength:
Video system
Dynamic range:
Signal/Noise ratio:
Frequency response
Channel Separation 1kHz
Channel Balance 1kHz
Audio out (analog audio)
Load impedance:
Video out Output level
Load impedance
Current consumption
DC-IN SUPPLY (9V)
Battery Charging Current
BATT. SUPPLY (7.2V)
Power Off
Playback with TFT on
Playback without TFT on
Battery time (playback)
Headphone out (headphone output load 2x16 ohm)
Maximum output power:
Frequency response:
SNR (A-wght):
THD ( :
0.2-20kHz)
Left-Right Channel
Separation:
Left-Right Channel
Balance:
Supported disc type
Video Playback
Formats:
Audio Playback
Formats:
204 x 168 x 33 mm
1.9kg
DC 12V 2.2A
20W
0 - 50 degC / 30 – 90% RH
650nm
NTSC / PAL / AUTO
>/=80dB
>/=85dB
20Hz-20kHz +/-1dB
>/=85dB
1dB
Output level: 2V +/- 10%
10Kohm
1Vp – p +/- 20%
75ohm
1.2A typical
0A
<1.2A typical
<600mA
>2.5 hours
>10mW
20Hz – 20kHz
80dB typical
<1%
32dB
1dB
Playback disc type:
Video Playback Format:
Audio Playback Format:
Disc Diameter
Factory Service Mode (FSM)
Procedure to check the software version of
your portable DVD Player
1. Connect AV cable to the player and to the TV
2. Press [SETUP] to enter the setup Meun
3. Press [RETURN] and then press "1" -> "2" -> "3"
by remote control
4. The display will show the software version as the
date of which the software was built on the bottom
of the screen.
Procedure to upgrade the software of your
portable DVD Portable
For the best performance of your DVD Portable.
Check www.philips.com/support for latest
software upgrades available.
1. Download the latest software from the Philips
support site
2. Unzip the files and then burn it into a CD-ROM to
3. make a disc for upgrade
4. Power on the Portable DVD Player with AC/DC
adaptor
5. Connect AV cable to the player and to the TV
6. Play CD-ROM for firmware upgrade
Warning: Do not unplug the AC adaptor during
firmware upgrade to prevent flash corrupt of the
set!!
7. Once upgrade is completed, the player is reset
automatically
8. Open the DVD door to remove the disc
DVD, Picture-CD,
SVCD, Video CD, MP3-
CD, CD-R/CD-RW,
WMA-CD, DVD-R, DVD-
RW, DVD+R, DVD+RW
DVD / VCD / JPEG
CD/MP3, MP3-DVD,
WMA
12cm