2 Place the display panel over the display back cover.
3 Route the display cable through the routing guide on the left display
hinge.
4 Route the antenna cables through the routing guide on the right display
hinge.
5 Replace the touch-screen board, if applicable:
Connect the touch-screen board cable to the connector on the touch-
a
screen board.
Replace the eight screws that secure the display panel to the display
b
back cover.
6 Replace the IR emitter board, if applicable:
Connect the IR emitter board cable to the connector on the IR
a
emitter board.
Replace the six screws that secure the display panel to the display back
b
cover.
7 Replace the camera module (see "Replacing the Camera Module" on
page 80).
8 Replace the display bezel (see "Replacing the Display Bezel" on page 60).
9 Replace the display assembly (see "Replacing the Display Assembly" on
page 58).
CAUTION:
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
Display Cable
Removing the Display Cable
1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the display assembly (see "Removing the Display Assembly" on
page 55).
3 Remove the display bezel (see "Removing the Display Bezel" on page 59).
4 Remove the camera module ("Removing the Camera Module" on
page 77).
64
Display
Before turning on the computer, replace all screws and ensure that no