Add Ipv6 Neighbors - TRENDnet TEG-40128 User Manual

TRENDnet User's Guide
4. In the left hand panel, click Tools, click on Configuration, and click Save.
5. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Add IPv6 neighbors

System > IPv6 Neighbor Settings
This settings allows you to manually define IPv6 supported neighboring devices on your
network.
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on IPv6 Neighbor Settings.
3. Review the settings. When you have completed making changes, click Apply to save
the settings.
© Copyright 2016 TRENDnet. All Rights Reserved.
"Access your switch management page"

Neighbor IPv6 Address: Specifies the neighbor IPv6 address.

Link Layer MAC Address: Specifies the link layer MAC address.
Click Add to save the entry to the list.

You can type in the specific address and click Find to find the entry to modify or
click Delete or delete the address. If the entries span multiple pages, you can
navigate page number in the Page field and click Go or you can click First,
Previous, Next, and Last Page to navigate the pages.
4. In the left hand panel, click Tools, click on Configuration, and click Save.
5. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-40128
12