六、Bus Control Adjustment 1)Factory Mode Using the romote controller to enter into Factory Menu. Press Menu to call main menu displaying on the screen. And then press “8”,“ 8”,“9”,“3”,“OK” in turn.You will see the screen displaying as following.You can check the version of the software,adjust some settings.But we don’t advise you change this settings.because of the TV has already hold in the state of optimality.If you have to chang this settings,please connect with the local service center.
Page 16
2.SW SW: This is the current software version.
Page 17
2)Aging Mode This is for factory run-in testing.
Page 18
3) RF Upgrade is for debugging, and do not change anything commonly.
Page 19
4)Service Menu is for debugging, and do not change anything commonly.
Page 20
5) Auto Color is for debugging, and do not change anything commonly. Remark: The date of the chart only is a example,please don’t adjust the factory mode base on it.
Page 25
Stuffing Options Sheet Index Revision History R3,R4,R9,R10 - IN, R5,R6,R7,R8 -OUT Boot-up from SPI FLASH * Revision Description P. Mgr. Date Page 01 - Title Sheet R203, R205 - OUT * Page 02 - DDR SDRAM I/F Initial Release R203, R205 - IN - LCD Backlight levels setup Peripheral parts of U27 revised.