GBC 17P Installation & Operation Manual page 18

6. Press the Up or Down arrow buttons to select a
program number 00 - 80.
7. Press ENTER to select the program.
• The LCD displays the program number and cut
values associated with the program. The first cut
is highlighted.
Figure 16. Rendering of Sample Program
8. Using the Keypad, enter the value for the first cut.
• Use the Down arrow to proceed to and enter
the next cut value.
• Continue this process until all cut values are
entered.
9. After the last cut value has been entered, key in a
value of 0.00. This signifies the end of your program
and will return the Back Gauge to your first cut value
position.
Figure 17. 00 Signifies End of Program
10. Press the Enter button to return the machine to the
home screen and auto setup for the first cut of your
program.
• The first step is highlighted.
• You are now ready to begin your job.
Page 6-2
ProCut 17P – Installation and Operating Instructions
11. Make the first cut by simultaneously pressing the
Clamp Cut and Cut buttons until it finishes cutting.
• The Back Gauge then moves to the second step
• Once all cuts in the program have been completed,
the Back Gauge and LCD return to the first step in the
program.
12. Press the Enter button to exit the program.
13. Press the arrow to select the mode used in the
program and press the Enter button.
• The program number blinks.
14. Use the Up or Down arrow to select program 00.
15. Press the Enter button.
16. Press the "C" button.
• The cutter is now back in manual mode.
cut position, which is highlighted on the LCD.
Figure 18. Operating the Machine