Table of Contents
Advertisement
3
Installation
3.1. Right place for installation
To ready the product for installation, see the
information in the user guide and make sure the
electric and water utilities are as required. If not,
call an electrician and plumber to arrange the
utilities as necessary.
B
WARNING:
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
B
WARNING:
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
A
WARNING:
narrow for the product to pass, remove the
door and turn the product sideways.
• Place the product on a flat surface to avoid
vibration.
• Place the product at least 30 cm away from the
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
• Do not expose the product to direct sunlight or
keep in damp environments.
• The product requires adequate air circulation to
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.
• Do not install the product in environments with
temperatures below -5°C.
The manufacturer assumes
The product's power cable
: If the door span is too
3.2. Attaching the plastic wedges
Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the screws on the
product and use the screws provided with the wedges.
2. Attach 2 plastic wedges on the ventilation cover
shown as j in the figure.
8 / 42 EN
Refrigerator / User Guide
Hide quick links:
Advertisement
Table of Contents
