Desa VML27NR Operation And Installation Manual page 21

oPERAting HEAtER
Continued
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:
1. Remove control cover log (see Figure 27,
page 20). Turn control knob clockwise
to the PILOT position. Replace
control cover log.
2.
If Using Optional Hand-Held Remote:
remote control manual OFF button.
WARNING: Make sure remote
sensor selector switch is in the
OFF position when you are away
from home for long periods of
time. Follow step 3 under Shut-
ting Off Heater, page 20.
MANUAL LIGHTING
pROCEDURE
1. Follow steps 1 through 5 under Lighting
Instructions, pages 19 and 20.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under Lighting Instructions, page 20.
OpTIONAL HAND-HELD
REMOTE OpERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
29). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 19.
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Adjust
flame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE
position (see Figure 30). Note: The burner may
light if hand-held remote was on when selector
switch was last turned off. You can now turn the
burner on and off with the hand-held remote
control unit.
111115-01F
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON
OFF
REMOTE
Use
Selector Switch in REMOTE
Position (Optional Hand-
Held Remote Control)
Figure 30- Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Hand-Held Remote Operation
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 31).
TO LOCK
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Indicator
Light
Figure 31 - On/Off Hand-Held Remote
www.desatech.com
Flame Adjustment
Piezo Ignitor
Knob
press both buttons on hand-held
press both buttons together
Control Unit (HRC100)
Control Knob
in On Position
Control
Button
1