Advertisement
Jumper Pin Location
The jumpers on headboards start with Pin 1 on the
leftmost side of the pin. Grouped jumpers increase in pin
size with each jumper added.
Figure 5. Pin Locations for a Single Jumper. Pin 1 is Located at the Leftmost Side
Pin 1 is Located at the Top-Left Corner and Increases in a Zigzag Fashion Shown in the Picture
Jumper/Header Functions & Default Positions
Table 1. JUMPERS AND HEADERS
Jumper/Header No.
Jumper/Header Name
P3
P4
P5
P6
P7
SPI Memory Selection
P8
P9
P10
AP0100AT2L00XUGAH−GEVB
Pin 1
and Increases as it Moves to the Right
Pin 1
Figure 6. Pin Locations and Assignments of Grouped Jumpers.
TRST_BAR
2−3 (Default)
SADDR
SPI_SDI_BAR
1−2 (Default)
STANDBY
2−3 (Default)
2−3 (Default)
GPIO_5
Open (Default)
+AVDD
Closed (Default)
+SVDDIO
www.onsemi.com
Pins 1 and 2
Pins 3 and 4
Pins 5 and 6
Pins 7 and 8
Pins 9 and 10
Pins
Open
OTPM Programming Voltage Not Supplied
Set to Normal Mode
Open
Set to Test Mode
Open
Analog Test 1 Header
GND; AP0100 in Host Mode
Open
SPI_SDI_SEL; AP0100 in Flash Mode
Active Mode
1−2
Standby Mode
2
Open
I
C IO Expander Control
EEPROM Disable/Flash Enable
Open
Flash Disable/EEPROM Enable
Serial IO Expander Control
1−2
Set to Normal
2−3
Set to Vertical Flip
Connects to On-Board Regulator +1V8, Internal
Regulator Use
Open
Disconnects from On-Board Regulator +1V8, External
Regulator Use
3−5
Select Demo 3 Baseboard Clock
2−4
Select Slave Clock (for Slave Sensor in Multi-Camera
Mode)
3
CONFIDENTIAL AND PROPRIETARY
NOT FOR PUBLIC RELEASE
Pins 1−4
Description
Advertisement
