Beko DFC05R10W User Manual page 30

Troubleshooting
Detergent remains in detergent dispenser.
• Detergent dispenser was damp when adding detergent. >>> Make sure that the
detergent dispenser is dried well prior to filling it with detergent.
• Detergent is added long before the washing process. >>> Pay attention to add
detergent shortly before start-up of the washing.
• Opening of the detergent dispenser lid is prevented during washing. >>> Place the
dishes in a way that will not prevent the detergent dispenser lid from opening and the
water going into the machine from impellers.
• Detergent is stored under unsuitable conditions. >>> If you are using powder
detergent, do not store the detergent package in humid places. Keep it in a closed
container if possible. For ease-of-storing, we recommend you to use tablet
detergents.
• Impeller holes are clogged. >>> Lower and upper impeller holes might be clogged
with food remnants such as lemon pips. Clean the impellers regularly as illustrated in
section "Cleaning and Care".
Decorations and ornaments on kitchen utensils are being erased.
C
Decorated glasses and decorated lustre porcelains are not suitable for washing
in the dishwasher. Manufacturers of some glassware and porcelain tableware
items do not recommend washing such kitchen utensils in the dishwashers
either.
Dishes are scratched.
C
Kitchen utensils that contains or are made of aluminum should not be washed
in dishwasher.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling hole
while adding salt. Spilled salt can cause scratches. Make sure that the salt reservoir
lid is tightly closed after finishing the filling process. Run the prewash programme to
remove the salt that spilled inside the machine. Since the salt granules that will remain
under the lid will dissolve during prewash, causing the lid loosen, check the lid once
again at the end of the programme.
• Water hardness setting is low or salt level is insufficient >>> Measure the hardness of
the supply water appropriately and check the water hardness setting.
• Dishes are not placed orderly in the machine. >>> When placing the glasses and other
glassware into the basket lean them not against other dishes but the edges or racks of
the basket or the glass support tines. Striking of the glasses to each other or to other
dishes due to the impact of water during washing can cause breaks, or scratches on
their surfaces.
/33 EN
30
Dishwasher / User's Manual