Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dancover Bermuda HE94000
Summary of Contents for Dancover Bermuda HE94000
- Page 1 Manual Heater Bermuda 08-06-2015...
- Page 2 INFRARED PATIO HEATER Safety Instructions and Operation Manual HE94000 Introduction Your infrared heater is heating in the way of radiation (no need for medium) so your infrared heater is effective. Because it doesn’t need to heat the ambient air (medium), it is good to be used in the open‐air as well. Important Safety Instructions When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or injury to persons, etc. Read through the operation and assembly instructions conscientiously before operating the appliance. Be sure to keep the manual in a safe place for future reference. If you pass the appliance on, pass on the instructions too. Read all instructions before using this heater ...
- Page 3 Do not try to repair by yourself when it is broken (such as cord, plug etc),please contact the service agent . If the appliance is located in bathroom, laundry areas and similar locations .Make sure the plug is not in the circumstance or take the necessary protection measures to prevent electric leakage of the plug Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it cannot be tripped over. Connect to properly grounded outlets only. To disconnect heater, turn controls to off, then remove plug from outlet. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. Always plug heaters directly into a wall outlet/receptacle. Try not use with an extension cord or relocatable power tap (outlet/power strip). Even use, make sure the current carrying capacity and rated voltage correspond to the relative regulation Check if the voltage indicated on the nameplate of the appliance corresponds to the local mains voltage before you connect the appliance. The appliance is not located immediately below a wall socket‐outlet. The casing and the front cover of the appliance become extremely hot during operation. Pay attention that, no combustible material due to Wind or other environmental influences covers or obstructs the appliance, such as curtains, marquees, flags, plastic foil etc. Do not touch the appliance. Caution! Risk of scald injury! In case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the appliance must be discontinued and remove the mains plug immediately. Do not try to repair the appliance by your‐self. Please contact with the service agent or a suitably qualified electrician for maintenance Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off before cleaning. Keep out of reach of children. In order to keep children from the dangers of electrical appliances, never leave them ...
- Page 4 Figure 1: Mounting bracket (wall Figure 2 Min. distance to floor, bracket) and anchor dowels provided. ceiling and wall Connection from the wall to the infrared heater. Figure 3: Tilt angle Cleaning and Maintenance This appliance consists of a robust and maintenance‐free stainless steel，aluminium casing and a protection cover. No user serviceable parts inside. Before cleaning， remove the plug from the power outlet and wait until the appliance is sufficiently cooled off. Wipe the appliance only with clean and lint‐free cloth or a soft brush. Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning! Can use alcohol to clean the appliance. To protect against electrical shock and danger of life, do not immerse cord, plug, or any part of the appliance in water or other liquid. For heating element replacement ，please contact the manufacturer or its service agent or a similarly qualified person. any other service contact with the service agent or a suitably qualified electrician. STORAGE Do not route cord when heater storage, or heater is not in use. Disposal In accordance with European Directive 2002/96/EG concerning used electrical and electronic appliances (waste electrical and electronic equipment – WEEE), please return any electrical equipment that you will no longer use to the collection ...
- Page 5 Specifications Specification HE94000 220‐240V ～ 50Hz Voltage (V) Power (W) 2000W Dimensions 545.0×100.0×160.0 W×H×D (m) Weight (kg) 2.5 Customer Service Repairs must be carried out by authorized specialists, thus ensuring electrical safety. Please contact with the service agent or a suitably qualified electrician. Improper repairs could lead to danger to the user. This warranty does not cover damage of failure which results from alteration, accident, misuse, abuse, neglect, commercial use or improper maintenance. In line with our policy of continuous product development we reserve the right to change the product and documentation specifications without notice. ...
Need help?
Do you have a question about the Bermuda HE94000 and is the answer not in the manual?
Questions and answers