Table of Contents
Advertisement
Lubrication and Greasing Instructions
The engine should be well oiled and greased in order to run properly.
You should regularly lubricate the engine to prevent it from squeaking. Use
light household oil and follow the lubrication points marked "L" in Fig. 5. Do
not over-oil. Use only a drop or two on each pivot point.
Lubricate Pick Up
Lubricate Pick Up
Roller (L)
Roller (L)
Figure 5. Lubrication Points on the Locomotive
The locomotive's internal gearing was greased at the factory and should not
need additional grease until after 50 hours of operation or one year, whichever
comes first. Follow the greasing instructions below. Note that in some tightly
packed engines you may need to move internal components temporarily in
order to access the gears.
1. To access the gear box, remove the cab from the chassis by unscrewing the
chassis screws as seen in Figure 6 and lifting the cab from the chassis.
Body Mount Screws
Body Mount Screws
Figure 6. Locations of the Body Mounting Screws
2. Once the body is removed, remove the trucks by unscrewing the black
Phillips motor mount screw located on the underside of the drive trucks (see
Fig. 7).
3. Once the motor mount screw has been removed, pull the motor away from
the truck block and lightly coat the motor worm gear and bronze drive gear (in
the truck block) with grease.
12
Premier U50C Diesel Engine Operating Instructions
Advertisement
Table of Contents
