Adjusting The Optional Settings - Heatmiser PRT-ETS Manual

Optional Features Continued
Feature 10 – Optimum Start: Optimum start will delay the start up of the heating system
to the latest possible moment to avoid unnecessary heating and ensure the building is
warm at the programmed time. The thermostat uses the rate of change information to
calculate how long the heating needs to raise the building temperature 1°C (with a rate
of change of 20, the thermostat has calculated the heating needs 20 minutes to raise the
building temperature 1°C) and starts the heating accordingly.
Feature 11 – Rate Of Change: This is the number of minutes the thermostat has
calculated it takes to raise your building temperature 1°C. The thermostat will continue to
monitor and learn the heat up time of your home to optimise heating efficiency.
Feature 12 - Programming Mode: The thermostat offers 2 programming methods.
Weekday/Weekend allows you to program 4 comfort levels for the weekdays and 4
different comfort levels for the weekend. In 7 Day program mode, each day has 4 comfort
levels that can be programmed independently.
21 TouchScreen Series

Adjusting the Optional Settings

To adjust the optional settings, follow these steps.
• Press PROG ....................................................................................................................
• Press SETUP ...................................................................................................................
• Use the Up/Down keys at the top of the screen to select the feature
number (shown on pages 19-21) and then use the Up/Down keys in
the center to adjust the setting .............................................................................
• Press DONE to confirm settings and exit ...........................................................
Model: PRT-ETS / PRT-ENTS
Feature Number
Setting Value
22