Saeco XSMALL HD8642 User Manual page 38

ENGLISH
36
Problem
The machine grinds the
coffee beans but no coffee is
brewed (see note).
The coffee is too weak (see
note).
Coffee is brewed slowly (see
note).
The drip tray gets filled al-
though no water is drained.
Note:
These problems can be considered normal if the coffee blend has been changed or if the machine has just been
installed. In this case, wait until the machine performs a self-adjusting operation as described in the "Saeco Adapt-
ing System" section.
Possible Cause
The brew group is dirty.
This might occur when the ma-
chine is automatically adjusting
the dose.
The coffee dispensing spout is
dirty.
This might occur when the ma-
chine is automatically adjusting
the dose.
The ceramic coffee grinder is set
to a coarse grind.
The coffee grind is too fine.
The brew group is dirty.
Water is drained automatically by
the machine into the drip tray to
manage the rinsing of the circuits.
Solution
Clean the brew group ("Brew Group
Cleaning" section).
Brew a few cups of espresso coffee
as described in the "Saeco Adapting
System" section.
Clean the coffee dispensing spout.
Brew a few cups of espresso coffee
as described in the "Saeco Adapting
System" section.
Adjust the ceramic coffee grinder to
a finer setting (see the "Adjusting the
Ceramic Coffee Grinder" section).
Change coffee blend or adjust the
grind setting as explained in the "Ad-
justing the Ceramic Coffee Grinder"
section.
Clean the brew group ("Brew Group
Cleaning" section).
This is a standard operating proce-
dure.