Denon AVR-S710W Owner's Manual page 58

Contents Connections
Wireless LAN
When connecting to a wireless LAN network, stand the rod antenna for
Bluetooth/wireless LAN connection upright on the rear panel.
See "Wi-Fi Setup" on how to connect to a wireless LAN router.
(v p. 190)
Internet
Router with access
point
FRONT FRONT CENTER SURROUND SURROUND
Front panel Display
Playback
Modem
To WAN side
SURROUND BACK SURROUND BACK
Rear panel
Settings
0 When using this unit, we recommend you use a router equipped with the following
functions:
0 Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
0 Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a
speed of 100 Mbps or greater.
0 Only use a shielded STP or ScTP LAN cable (readily available at electronics
stores). (CAT-5 or greater recommended)
0 The normal shielded-type LAN cable is recommended.
If a flat-type cable or unshielded-type cable is used, other devices could be
affected by noise.
0 When using a router that supports the WPS （Wi-Fi Protected Setup） function, Wi-
Fi connection can be carried out easily.
0 When using this unit connected to a network with no DHCP function, configure the
IP address, etc. in "Network". (v p. 189)
NOTE
0 The types of routers that can be used depend on the ISP. Contact your ISP or a
computer shop for details.
0 This unit is not compatible with PPPoE. A PPPoE compatible router is required if
your contracted line is not set using PPPoE.
0 Do not connect a NETWORK connector directly to the LAN port / Ethernet
connector on your computer.
0 Various online services may be discontinued without prior notice.
58
Remote
Tips Appendix
Index