Troubleshooting - Oster FPSTJE318C Instruction Manual

Your Oster appliance has been carefully designed to give you many years of trouble
®
free service. In the unlikely event that your new appliance does not operate properly,
please review the following potential problems and try the steps recommended
BEFORE you call or take it to an Authorized Oster
PROBLEM
Juice Extractor will not work
after switching on "I" or "II".
Motor makes loud noise and
unit starts vibrating.
Motor appears to stall
when juicing.
Too much pulp build up.
Pulp too wet and reduced
juice extraction.
Juice leaks between the rim
of the Juicer and Juice
Extractor Cover.
TR O U BL E S HOOT ING
• Stainless steel locking arm may not be locked properly in
its position.
• Turn off and unplug unit and ensure all parts are
assembled properly.
• Turn off and unplug unit and check if there is any residue
blocking the unit.
• Turn off and unplug unit and ensure all parts are assembled
properly.
• Juicing overripe fruits may produce too much pulp and clog
the filter. Turn off and unplug unit and clean the
filter thoroughly.
• If pulp starts building up under the lid, slow down the juicing
process. Turn off and unplug unit and clean the filter basket,
the stainless steel filter and the lid.
• Follow the instructions to disassemble the unit included in
the "After Using Your Juice Extractor" section. Clean up
pulp from the filter.
• Try a slower juicing action. Remove stainless steel mesh
filter and thoroughly clean mesh with a nylon brush. Rinse
the filter basket with hot water. If the fine mesh holes are
blocked, soak the basket in a solution of hot water with 10%
lemon juice to unblock the holes or wash in the dishwasher.
This will remove excess fiber build up (from fruit or
vegetables), which could be reducing the flow of juice.
• Try a slower juicing action by pushing the Food Pusher
down slower.
En g lish -15
Service Center.
®
SOLUTION