Table of Contents
Advertisement
2.2 Description of Camera Parts
(1)
Lens Mount
This mount is used to install a CS-mount lens. CS-adaptor ring is required
when using a C mount lens.
(2)
Camera Mounting Screw Holes
Screw hole for mounting the camera.
(3)
Mount Adaptor
The adaptor can be attached onto the top or the bottom of the unit.
(4)
Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto-iris lens (not supplied) with DC control
signal.
PIN
NO.
1
2
3
4
(5)
Video Connector
Video can be outputted via this BNC connector. (75Ω).
(6)
Iris Mode Selection Switch
Select DC or VIDEO mode according to the lens.
(7)
OSD Control Buttons
ENTER button
UP & DOWN buttons
LEFT & RIGHT buttons
Copyright © 2010. All Rights Reserved.
www.okinausa.com
VIDEO
DC
CONTRO
DC + 12V
L -
CONTRO
NC
L +
IRIS
DRIVE +
GND
DRIVE -
4
REV122010-V17
Advertisement
Table of Contents
