Table of Contents
Advertisement
Image Orientation
The orientation of the image displayed is critical to
safe vehicle operation. An object on the right side of
your vehicle needs to be seen on the right side of
the displayed image.
Orientation Requirements
Generally, if your display is facing rearwards, you
would want a Mirror image displayed from a camera
facing rearward and a True image displayed from a
(Loosen screw, rotate cover)
camera facing forward. The image orientation of
cameras on the right or left side of a vehicle
depends on how far off of center they are facing. For
example; a camera mounted on the right side at 90º
off of the front would usually require a true image to
be displayed. But set the camera to 91º off of the
front and a mirror image may be required. Be sure to
confirm the image(s) displayed are appropriate for
your application before operating the vehicle.
The same method is used for the CVC500AHXL
How to Change Your Image
INTEC's CVC Series cameras are set as default at
the factory to display a mirror image when used with
our CVD or CVM Series displays and monitors.
Should you need to change the default image the
CVC500AH(XL) is equipped with a push button
switch on the back side of the camera.
To access the switch you will need to loosen the
switch
cover.
This
is
done
with
a
Phillips
screwdriver. Once the screw has been loosened
simply swing the cover out of the way and push the
switch. Don't forget to put the cover back and tighten
the screw once you've got your image set. Always
confirm proper orientation before operating your
vehicle.
© INTEC Video Systems, Inc.
11
Revision F May 2013
Advertisement
Table of Contents
