Advertisement
4. MOUNTING and WIRING CONNECTIONS
Run coaxial cable for video and 18 gauge wires for power to the installation location prior to
installing the camera. The coax cable must be terminated with a male BNC connector. The
power wires are to be terminated with a male 5.5mm power pigtail.
a. This camera must be mounted on a ceiling or other horizontal surface. Proper image
cannot be attained with vertical mounting.
b. Hold the camera to the ceiling while monitoring the image with a portable monitor or
meter.
c. Observe the image while rotating the camera. When the desired view is achieved,
mark the mounting holes on the ceiling.
d. Connect the power supply's 5.5mm male power pigtail to the camera's female power
connector.
e. Connect the camera's female BNC video output connector to the video coaxial cable's
male BNC connector.
f.
Feed all wires up into the ceiling.
g. Use the included mounting hardware to secure the camera to the ceiling.
h. NOTE: No adjustment of the viewing angle is possible once the camera is mounted.
Ensure proper positioning prior to securing the camera.
i.
Connect power supply's AC plug to a suitable AC power outlet.
v1.2 8/11/11
4
Advertisement
