JAI AM-201CL User Manual page 64

Acquisition frame rate
OFF
Timed
Exposure
Control
Trigger width
(Trigger)
PIV
Pre-dump
Source
Trigger
Control
Activation
Gain
White balance
Black level
LUT
Gamma
Flat Field Compensation
Blemish Compensation (Bright)
Color interpolation
Test pattern
Temperature sensor
Serial communication
Power
Lens mount
Flange back
Sensor alignment
Optical filter
Operating temperature
Humidity
Storage temp/humidity
Vibration
Shock
Regulatory
Size
Weight
Note1): Approximately 5 minutes pre-heating is required to get the mentioned specifications.
Note2): The above specifications are subject to change without notice.
AM-201CL / AB-201CL
Frame rate can be varied from 64.2Hz to 0.5Hz
10μs to2s(if frame line number is changed), 1μs step
Line 0=Camera Link CC1 or Line1=Hirose 12P 10pin
Level High or Level Low (if trigger width is used)
Manual/Auto : -3dB to +24 dB
(1 Step 0.0359 dB)
Fine gain (Digital gain)
(1step=0.00012 times)
-
0 LSB to 255 LSB can be changed, 1 step is 0.25dB
OFF: γ=1.0, ON= 256 points can be set
0.45 to 1.0 can be set, Adjusting step is 0.05
Compensated by 128 x 128 pixels block
maximum 64 pixels for dark and bright compensation per 1 tap
(note: black compensation is only by factory preset)
-
OFF/Black-white/Gray H-ramp/
Gray V-ramp/white(100%)
-55 to +125ºC (measuring range), resolution is 0.0625ºC
DC+12V to +24V ± 10%, 7.8W (at normal operation, DC+12V)
The rear protrusion on C mount lens must be less than 10mm.
17.526 mm, tolerance 0 to -0.05 mm
X and Y axis: ± 0.1 mm ( at center)
- Protection glass only
-25C to +60C/20% to 80 % non-condensing
CE (EN61000-6-2 and EN61000-6-3), FCC part 15 class B, RoHS, WEEE
- 62 -
10μs to 2 sec.
Rising edge or falling edge
Manual/Auto : 0dB to +24 dB
(1 Step 0.0359 dB)
Fine gain (Digital gain)
(1step=0.00012 times)
ON: One push white balance
Range: 3200K to 9000K
32 LSB at 10-bit output,
(at 10-bit output)
Built in,
3 x 3 interpolation matrix
OFF/Color bar/Gray H-ramp /
Gray V-ramp /White(100%)
Camera Link or Hirose 12-pin
C mount
Optical low pass filter
-5C to +50C
20 – 80% non-condensing
10G (20Hz to 200Hz, XYZ)
70G
55 x 55 x 69 mm (W x H x D)
280g
OFF: Manual