Network Setup - Samsung HT-H5500W User Manual

Settings

Network Setup

When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's software
through the network connection.
Configuring Your Network Connection
To begin configuring your network connection, follow
these steps:
1. In the Home screen, select Settings, and then
press the E button.
Select Network, and then press the E button.
2.
3. Select Network Settings, and then press the
E button.
4. Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks on the bottom right of this page.
Wired Network
K
Wired – Automatic
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the E button. The product detects
the wired connection, verifies the network
connection, and then connects to the network.
2. When it is done, highlight OK, and then press
E button.
K
Wired - Manual
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the E button.
The product searches for a network, and then
displays the connection failed message.
✎
If it is possible to connect the home theater to
your network wirelessly, select Change Network
at this point, change the Network Type to
Wireless, and then go to the instructions for
wireless networks on the bottom right of this
page.
Network Settings
Wired network connection failed.
IP auto setting failed. Try the following to set up IP automatically, or set up the IP manually by
selecting 'IP Settings'.
- Ensure that DHCP server is enabled on the wireless network, and then unplug and re-plug the wireless
network.
- Contact your Internet Service Provider for more information.
Change Network
2. Use the ◄► buttons to select IP Settings,
and then press the E button. The IP Settings
screen appears.
3. Select the IP Setting field, and then set it to
Enter manually.
4. Select a parameter to enter (IP Address, for
example), and then press E . Use the number
keypad on your remote control to enter the
numbers for the parameter. You can also enter
numbers using the ▲▼ buttons. Use the ◄►
buttons on the remote control to move from
entry field to entry field within a parameter. When
done with one parameter, press the E button.
5. Press the ▲ or ▼ button to move to another
parameter, and then enter the numbers for that
parameter following the instructions in Step 4.
6. Repeat Steps 4 and 5 until you have filled in all
parameters.
✎
You can get the network parameter values from
your Internet provider.
7. When finished entering all the parameter values,
select Return ( ' ), and then press the E
button. The home theater verifies the network
connection and then connects to the network.
Wireless Network
You can set up a wireless network connection in three
ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
Before you configure the wireless network
connection, disconnect any wireless network devices
currently connected to the product or, if applicable,
the product's current wired connection.
20
- English
MAC Address XX:XX:XX:XX:XX:XX
IP Address 0. 0. 0. 0
Subnet Mask 0. 0. 0. 0
Gateway 0. 0. 0. 0
DNS Server 0. 0. 0. 0
IP Settings Retry Close
a Previous d Skip < Move " Select