Table of Contents
Advertisement
Problem
Chaotic image, noisy
No image can be
displayed
Blurry or distorted
image
(no sound or low
volume)
Unusual image is
displayed
No sound is produced
d
Sound level is low or
sound is distorted
Sound is unusual
s
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Cannot connect to the
network
Cannot select the
file during DLNA
operations
Cannot access the
Internet contents
The TV goes into
Standby mode
The remote control
does not work or is
intermittent
TH_L37U30KMTX_EN.indd 69
TH_L37U30KMTX_EN.indd 69
Change the setting of [P-NR] in the Picture Menu (to remove noise).
●
(p. 24)
Check nearby electrical products (car, motorcycle, fluorescent lamp).
●
Is [Colour] or [Contrast] in the Picture Menu set to the minimum?
●
(p. 24)
Reset channels
(p. 31)
●
Turn the TV Off with Mains power On / Off switch, then turn it On
●
again.
●
Is "Sound Mute" active?
●
Is the volume set to the minimum?
Sound signal reception may be deteriorated.
●
Set [MPX] in the Sound Menu to [Mono]
●
Set the sound setting of the connected equipment to "2ch L.PCM".
●
Check the [HDMI1 / 2 / 3 Input] setting in the Sound Menu.
●
If digital sound connection has a problem, select analogue sound
●
connection.
(p. 62)
Check that the HDMI cable is connected properly.
●
Turn the TV and equipment Off, then turn them On again.
●
Check the input signal from the equipment.
●
Use an equipment compliant with EIA/CEA-861/861B.
●
Check that the LAN cable or Wireless LAN Adaptor is connected
●
properly.
(p. 45)
Check the connections and settings.
●
Check the network equipment and network environment.
●
If the problem persists, consult your Internet Service Provider or
●
telecommunications company.
Is media server prepared?
●
Check applicable data format.
●
Check the connections and settings.
●
The server or connection line might be busy now.
●
●
Auto power standby function is activated.
●
The TV enters Standby mode about 30 minutes after analogue
broadcasting ends.
Are the batteries installed correctly?
●
Has the TV been switched On?
●
●
Point the remote control directly at the front of the TV
(within about 7 m and a 30 degree angle from the front of the TV).
●
Place the TV away from sunshine and do not let other sources of
bright light to shine on the TV's remote control signal receiver.
Actions
(p. 11)
(p. 27)
(p. 63)
(p. 46 - 48)
(p. 44)
(p. 65 - 66)
(p. 46 - 48)
(p. 8)
(p. 27)
(p. 53, 58 - 60)
69
3/18/2011 4:11:27 PM
3/18/2011 4:11:27 PM
Advertisement
Table of Contents
