Care And Maintenance; Enamelled Parts - CDA DK1151 Installation, Use And Maintenance Manual

Table of Contents

Advertisement

Care and Maintenance

It is advisable to clean when the appliance is cold and especially for
cleaning the enamelled parts.
Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on
the surfaces.
Avoid using cleaning products with a chlorine or acidic base.
WARNING
When correctly installed, your product meets all safety requirements
laid down for this type of product category. However special care
should be taken around the rear or the underneath of the appliance
as these areas are not designed or intended to be touched and may
contain sharp or rough edges, that may cause injury.
Inside of Oven
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm
water.
Suitable proprietary chemical cleaners may be used after first consulting
with the manufacturers recommendations and testing a small sample of
the oven cavity. Abrasive cleaning agents or scouring pads/cloths should
not be used on the cavity surface.
NOTE: The manufacturers of this appliance will accept no responsibility
for damage caused by chemical or abrasive cleaning.

Enamelled Parts

All the enamelled parts must be cleaned with a sponge and soapy water
only or other non-abrasive products.
Dry preferably with a micro fibre or soft cloth.
Stainless Steel, Aluminium, Painted Parts and Silk-
screen Printed Surfaces
Clean using an appropriate product. Always dry thoroughly.
Stainless steel surfaces: can be cleaned with an appropriate stainless steel
cleaner.
IMPORTANT: these parts must be cleaned very carefully to avoid
scratching and abrasion. You are advised to use a soft cloth and neutral
soap.
Glass Control Panel
Clean using an appropriate product. Always dry thoroughly.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
control panel since they can scratch the surface, which may result in
shattering of the glass.
IMPORTANT:
Before any operation
of
cleaning
and
m a i n t e n a n c e
disconnect
the
appliance
from
the
electrical supply.
ATTENTION:
Let the
oven
cool
down and pay special
attention no to touch
the
hot
heating
elements inside the
oven cavity.
CAUTION:
Do not use abrasive
substances
or
nonneutral detergents
as
these
will
irreparably
damage
the surface.
CAUTION:
Do not use a steam
cleaner because the
moisture can get into
the
appliance
thus
make it unsafe.
CAUTION:
Do not store
flammable material
in the oven.
CAUTION:
Do
not
use
harsh
abrasive cleaners or
sharp metal scrapers
to clean the oven door
glass since they can
scratch the surface,
which may result in
shattering of the glass.
17

Advertisement

Table of Contents
loading

Table of Contents