Mitsubishi Electric MJ-E16VX-A1 Instruction Manual page 24

Maintenance (Cont.)
Photocatalytic filter
1
Remove the front panel and
pre-filter.
1 Remove by holding
the bottom.
2
Remove the photocatalytic filter.
3
Soak the photocatalytic filter in
water.
Do not use detergent or hot water.
Also, do not brush or rub while
soaking as this may damage the filter.
• Stains may remain on the filter, but should not
affect performance.
• The filter can be soaked for a total of eight
times. After that, replace with a new filter.
24
Once every three months
Front panel
Pre-filter
2 Remove by
holding the
tabs.
Performance is
unaffected even if the
metal fins inside the main
unit are slightly bent.
Photocatalytic
filter
Pre-filter
Soak in cool to
lukewarm water for 30
minutes.
Soaking the filter in water, and leaving it to dry in the sun
renews the performance and prolongs service life. Perform this
every three months.
4
Dry the photocatalytic filter.
Do not hang with pegs as this may
damage the filter.
Do not use the filter while wet.
5
Fit the photocatalytic filter.
With the strips facing up, set the
photocatalytic filter inside the tabs
on the pre-filter.
6
Attach the pre-filter and front
panel.
1 Attach by holding
the tabs.
Dry well in the sun (The
performance of the filter
renews with soaking,
and the photocatalytic
effect of the sunlight
removes remaining
odorants).
Tabs (6)
2 Hook the top edge
to the top part of
the unit and push
the bottom in.