Floor Mounting Away From Wall; Connecting To Gas Supply - Mr. Heater MHVFG30TB NG Operating Instructions And Owner's Manual

Unvented natural gas fired garage heater
Table of Contents

Advertisement

1. Drill holes at marked locations using 5/16" drill
bit. For solid walls (concrete or masonry), drill
at least 1" deep.
2. Fold wall anchor as shown in figure 8 below.
Figure 8.
3. Insert wall anchor (wings first) into hole. Tap
anchor flush to wall.
4. For thin walls (1/2" or less) insert red key into
wall anchor.
5. Place mounting bracket onto wall. Line up
holes on each end of bracket with wall anchors.
6. Insert mounting screws through bracket and
into wall anchors.
7. Tighten screws until mounting bracket is firmly
fastened to wall.
Placing Heater on Mounting Bracket
1. Locate two horizontal slots on back pane of
heater (see figure 9).
2. Place heater onto mounting bracket. Slide hori-
zontal slots onto stand-out tabs on mounting
bracket.
Figure 9.
Installing Bottom Mounting Screws
1. Locate two bottom mounting holes. These
holes are near bottom on back panel of heater
(see figure 10).
Screw
hole
Figure 10
2. Mark screws locations on wall.
3. Remove heater from mounting bracket.
Horizontal Slots
Mounting Bracket
mounted to wall
Screw
hole
Unvented Natural Gas Vent Free Heaters
4. If installing bottom mounting screw into hollow
or solid wall, install wall anchors. Follow steps 1
through 4 under Attaching to Wall using Anchor.
If installing bottom mounting screw into wall
stud, drill holes at marked locations using 9/64"
drill bit.
5. Re-place heater onto mounting bracket.
6. Place spacers between bottom mounting holes
and wall anchor or drilled hole.
7. Hold spacer in place with one hand. With the
other hand, insert mounting screw through
bottom mounting hole and spacer. Place tip of
screw in opening of wall anchor or drilled hole.
8. Tighten both screws until heater is firmly se-
cured to wall. Do not over tighten.
Note: Do not re-place front panel at this time. Re-
place front panel after making gas connections and
checking for leaks.

CONNECTING TO GAS SUPPLY

WARNING: A qualified service person must con-
nect heater to gas supply. Follow all local codes.
8
Installation Instructions and Owner's Manual

Advertisement

Table of Contents
loading

Table of Contents