Kenmore 721.63662 Service Manual page 16

B. REMOVING THE OUT CASE(Figure 8)
(1) Remove the vent grille by removing two screws
securing it to the out case.
(2) Remove two screws securing it to the air duct.
(3) Remove the mounting plate by turning the screws
(1 or 2 screws) securing it to the out case.
(4) Remove two screws on the left central edge and
two screws on the right central edge of Base plate.
Remove the Mount, All from the out case by
removing one screw securing it to the out case.
(5) Remove four screws of the rear cavity.
(6) Remove the outcase with disconnecting power
cord connector.
Door
Vent Grille
Controller
Figure 8
7-5
Mount, All
Power code
Mounting
Plate
Out Case