Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Omega OG30XA
Summary of Contents for Omega OG30XA
- Page 1 OG30XA cooktop...
- Page 2 Dear customer, We thank you and congratulate you on your choice. This new carefully designed product, manufactured with the highest quality materials, has been carefully tested to sa- tisfy all your cooking demands. We would therefore request you to read and follow these easy instructions which will allow you to obtain excellent results right from the start.
-
Page 3: Installation
INSTRUCTIONS FOR USE FOR VITROCERAMIC HOBS SEE ADDITIONAL INSTRUCTIONS Installation All the operations concerned with the installation (electrical connection) must be carried out by qualified technicians, in terms with the standards in force. For specific instructions, kindly read the part reserved for the installation technician. Gas burners (Fig. - Page 4 Fig. 1a...
- Page 5 Fig. 1 b...
- Page 6 Vitroceramic Heating elements Electrical plates (Figg. 2-3-1a-1b). Rotate the knob towards the position required for cooking and bear in mind that the higher the number, the higher the heat output. See table "use of electrical plates". The pilot light on the stove panel level signals that the plate is "on". Some types of pilot lights will maintain some slight luminescence even after disconnection.
- Page 7 corrosive products (found on the market). Avoid chlorine-base products (bleach, etc.); • avoid leaving acid or alkaline substances on the working area (vinegar, salt, lemon juice, etc.). • the wall baffle and the small covers (mobile parts of the burner) must be washed frequently with boiling water and detergent, taking care to remove every possible encrustation.
- Page 8 Fig. 5 WARNING CRYSTAL HOBS ‘A’ ‘B’ DO NOT TIGHTEN SCREW EXCESSIVELY ONE TURN MAX WILL BE SUFFICIENT AFTER CORRECTLY FITTING SHAFT INTO PLACE AS SHOWN IN THE PICTURE ENSURE THAT THE SUPPORTING SURFACE IS PERFECTLY EVEN FIT THE APPROPRIATE EXPANDED SEAL CRYSTAL HOBS MUST NOT BE SUBJECTED TO STRAINS CAUSED BY UNEVEN SUPPORTING SURFACES use of electrical plates - Vitroceramic Heating elements...
-
Page 9: Instructions For The Installer
INSTRUCTIONS FOR THE INSTALLER Installation These Instructions are for the qualified technician, as a guide to the installation, adjustment and maintenance, according to the laws and standards in force. Any of these operations must always be carried out when the appliance has been disconnected from the electric system. - Page 10 (the yellow/green earth cable must not be interrupted by the switch). The plug or om- nipolar switch must be easily reached on the installed equipment. The manufacturers decline any responsibility in the event of non-compliance with what is described above and the accident prevention norms not being respected and followed.
-
Page 11: User Characteristics
USER CHARACTERISTICS GAS BURNERS FEED BURNER Ø INJECTORS THÉRMAL CONSUMPTION CAPACITY TYPE PRESSURE mbar 1/100 mm fast 155/129 3000 Natural gas semifast 117/101 1750 10/20 auxiliary 92/77 1000 wok DUAL 70A-150B/63A-121B 3500 wok DUAL 70A-170B/63A-140B 4250 fish fast 87/94 3000 semifast 66/70 1750... - Page 12 The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing or copying errors. We reserve the right to make on our own products those changes to be considered necessary or useful, without jeopardizing the essential characteristics. COD.