Loading Paper; Loading Paper In Tray 1 - Konica Minolta Bizhub 165 User Manual

10
10.1.2

Loading paper

This section describes how to load paper into each paper tray.
If printing stops due to the paper tray being empty, load paper into the paper tray. For the types of paper to
be used, refer to page 12-3.

Loading paper in Tray 1

0 Make sure that the original and the loaded paper have the same orientation. Otherwise, some parts of
the image may be lost.
1
Pull out Tray 1.
2
Press down on the Paper-Lifting Plate until it locks into place.
% 1. Paper Take-Up Roller
NOTICE
Be careful not to touch the Paper Take-Up Roller.
3
Load the paper into the paper tray so that the side of the paper to
be printed on (the side facing up when the package was un-
wrapped) faces up.
% Do not load so many sheets of paper that the top of the stack
is higher than the , mark.
% If paper is curled, flatten it before loading it.
% Allows you to load up to 250 sheets of plain paper, or 20
sheets of card in the paper tray.
4
Slide the Lateral Guides to fit the size of paper being loaded.
% Be sure that the Lateral Guides are slid up against the edges
of the loaded paper.
5
Close Tray 1.
6
Press the Start key to restart printing.
10-4
Paper 10.1
1
bizhub 165