LG GSA-4167B Owner's Manual page 9

To Install as a Slave Drive
To install the drive as a Slave, change the jumper setting on the rear panel to SL.
Connecting the Power Connector
Connect the power cable from the computer's power supply to the socket on the drive unit,
fitting the connector firmly into the power in connector. If there is no spare power cable
available in the computer, you will have to purchase a splitter cable of a suitable type.
Beveled edge up
Connecting the Interface Connector
Connect the 40-pin IDE cable to the back of the Super Multi DVD Drive, making sure the
coloured (red) stripe on the IDE cable is connected to pin 1 on the Super Multi DVD drive
(Pin 1 is closest to the Power Connector).
Master drive
(Booting hard disk)
Slave drive
- OR -
(Super Multi
DVD Drive)
(Jumper set to
Slave)
Pin1
Red-edge
Master drive
(Booting hard disk)
Primary
connector
NOTE : Improper connection may damage
the drive and void the warranty. Generally,
the power connector can only fit one way.
NOTE : Generally, the IDE connector is
keyed and will only fit one way.
6
Master drive
(Other IDE drive)
Slave drive
(Super Multi
DVD Drive)
(Jumper set
to Slave)
Secondary
connector