Table of Contents
Advertisement
1. Positive power connector +
Connect the earth lead to by inserting and twisting until tight and the earth clamp to
work/bench.
2. Gas outlet
Connect the torch gas hose
3. Negative power connector -
Connect TIG Torch Dinze to power connector by inserting and twisting until tight
4. Torch control socket 7-Pin
Connect torch control plug
To avoid a High Frequency shock keep the TIG torch in good condition and replace if any of the
insulation is damaged.
Connect the gas input hose to gas regulator and use 'Pure Argon' Gas, available from local
suppliers. Set gas flow/pressure to 8-12 LPM.
Make sure gas bottle is secured to avoid injury.
Remote Foot Pedal connection.
Disconnect TIG Torch switch plug from torch control socket (Fig2.4) and connect plug from foot
pedal.
Connections for TIG (GTAW) Welding
Fig 2
9
Advertisement
Table of Contents
