Connecting Water Supply - Beko WDA 105614 User Manual

Installation
1
1 Loosen all bolts with the tool supplied in the User Manual bag until they turn freely. (C)
2 Remove transportation safety bolts by turning them gently.
3 Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel. (P)
C NOTE
¾ Keep the transportation safety bolts in a safe place to reuse when the machine needs to be moved again in the future.
¾ Never move the product without the transportation safety bolts properly fixed in place!
3.4 Flush usage with the bench
CAUTION
¾ Your machine should never be operated without the top plate.
A
¾ When the Washer-Dryer is placed under the bench, front of the machine should never be blocked by the
cupboard door.
¾ When the Washer-Dryer is placed under the bench, air vents must be bored into the left and right sides of the
cupboard.
NOTE
¾ Follow the above dimensions when installing the product under the bench. These dimensions are indispensable to avoid
C
any change in the performance of your machine.
¾ Drying washing machine can be used under a bench if the height of the bench allows.
¾ At least 3 cm clearance must be left between the sides and the back of the product and the wall when it is installed under
the bench or in a cupboard.

3.5 Connecting water supply

NOTE
¾ The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
C
10 – 80 litres of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a pressure
reducing valve if water pressure is higher.
¾ If you are going to use the double water-inlet product as a single (cold) water-inlet unit, you must install the supplied blind
stopper to the hot water valve before operating the product. (Applies for the products supplied with a blind stopper group.)
CAUTION
A
¾ Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will
get damaged or the product will switch to protection mode and will not operate.
¾ Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
8 / EN
2 3
65,5 cm
59,5 cm
84,0 cm
1,4 cm
Washer-Dryer