Xlr Out Polarity ( Avp-A1Hdci Only); Poa Setting ( Avp-A1Hdci Only); Volume Control ( Avp-A1Hdci; Source Delete ( Avp-A1Hdci - Denon AVR-5308CI Owner's Manual
Av surround receiver and av surround pre-amplifier
Hide thumbs
Also See for AVR-5308CI:
- Service manual (241 pages) ,
- Owner's manual (132 pages) ,
- Code list (16 pages)
Table of Contents
Advertisement
s XLR Out Polarity
AVP-A1HDCI
Set to switch the XLR pre-out terminal polarity.
[Selectable channels]
Front L
Front R
Center
Surround L
Surround R
Surround Back L
Surround Back R
Front Height L
Front Height R
Front Wide L
Front Wide R
Subwoofer 2
Subwoofer 3
[Selectable items]
XLR
q GROUND
w HOT
e COLD
XLR (INV)
q GROUND
w COLD
e HOT
d POA Setting
Set when connecting the receiver to a POA-A1HDCI.
POA LINK
Set when connecting the receiver to a POA-A1HDCI through a
CONTROL LINK.
Subwoofer 1
[Selectable items]
POA 1/POA 2
Set POA-A1HDCI for which the MODE select switch is set to "1" or
"2" .
See the POA-A1HDCI operating instructions.
n Input Selector
Select the setup channel.
[Selectable items]
Select the connector input to be used for each channel.
[Selectable items] RCA
n Power Amp
Select the setup channel.
[Selectable items] L1/L2
Set the power amp usage for each channel.
[Selectable items] NORMAL
LINK Check
Check CONTROL LINK.
AVP-A1HDCI
OFF
ON (Single)
ON (Dual)
L1
R1
L2
R2
L3
R3
L4
R4
L5
R5
XLR
OFF
L3/L4
L5/R5
R1/R2
R3/R4
BI-AMP
BRIDGE (BTL)
0
s Volume Control
AVR-5308CI
f Volume Control
AVP-A1HDCI
Set the MAIN ZONE volume setting.
Volume Limit
Make a setting for maximum volume.
[Selectable items]
OFF
–20dB
–10dB
Power On Level
This sets the volume set when the MAIN ZONE's power is turned on.
[Selectable items] Last
– – –dB
–80dB ~ 18dB
Mute Level
This sets the amount of attenuation of the volume when the mute
mode is set in the MAIN ZONE.
[Selectable items]
Full
–40dB
–20dB
d Source Delete
AVR-5308CI
g Source Delete
AVP-A1HDCI
Remove input sources that are not used from the display.
[Selectable items]
ON
Delete
NOTE
• Input sources being used in the various zones cannot be deleted.
• Input sources set to "Delete" cannot be selected from GUI menu
SOURCE SELECT
"Source Select" or using the
SOURCE SELECT
or
button on the remote control unit.
0dB
knob on the main unit
Advertisement
Table of Contents
