LG LP070CED-Y8 Manual page 27

7. Remove the screw that attaches the electric heater wire to
the side of the indoor fan housing.
8. Remove the 3 screws which fasten the top cover assembly.
Figure 33
9. Position water spraying plastic tube into the electric heater
cover. Make sure that the three pairs(total of six) of plastic
tongues snap into the corresponding metal slots of the
heater frame as shown in fig. 34. Then install one of the
three rubber elbows(ref. fig. 38) at the inlet of the spraying
tube and through the rubber grommet.
Figure 34
10. Place the top cover assembly back into the unit.
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
11. Install tube #1 and tube #2 (ref. fig. 38) on the pump
assembly using the rubber elbows as shown in fig. 28.
Figure 35
12. Position pump assembly to the basepan as shown in fig.
36 and fasten the pump bracket to the basepan using the
three screws provided.
Figure 36
13. Insert tube #2 of the pump assembly through the plastic
grommet of the sheet metal partition as shown in fig. 37.
Then connect the end of tube #2 to the plastic elbow
coming out of the inlet of the spraying tube.
Figure 37
- 27 -
LGE Internal Use Only