Network Connection And Setup; Connecting The Network Encoder - Samsung SPE-400 User Manual

network connection and setup

You can set up the network settings according to your network configurations.
CONNECTING THE NETWORK ENCODER DIRECTLY TO
LOCAL AREA NETWORKING
Connecting to the network encoder from a local PC in the LAN
1. Launch an Internet browser on the local PC.
2. Enter the IP address of the network encoder in the address bar of the browser.

M
A remote PC in an external Internet out of the LAN network may not be able to connect to the
network encoder installed in the intranet if the port-forwarding is not properly set or a fi rewall is set.
In this case, to resolve the problem, contact your network administrator.

By factory default, the IP address will be assigned from the DHCP server automatically.
If there is no DHCP server available, the IP address will be set to 192.168.1.100~103(CH 1~CH 4).
To change the IP address, use the IP Installer.
For further details on IP Installer use, refer to "Static IP Setup". (Page 27)
22_ network connection and setup
Network Encoder
Network Encoder
Local PC
<Local Network>
INTERNET
Firewall
DDNS Server
(Data Center, KOREA)
External Remote PC