Connecting Water Supply - Beko WMD 261 W Installation & Operating Instructions And Washing Guidance

the User Manual bag into the holes on
the rear panel. (P)
in a safe place to reuse when the
washing machine needs to be moved
again in the future.
Never move the product without the
transportation safety bolts properly
fixed in place!

Connecting water supply

The water supply pressure required
from the fully open tap in one minute
to have your machine run smoothly.
water pressure is higher.
Models with a single water inlet
should not be connected to the hot
water tap. In such a case the laundry
will get damaged or the product will
switch to protection mode and will not
operate.
Do not use old or used water inlet
hoses on the new product. It may
cause stains on your laundry.
Connect the special hose supplied
with the product to the water inlets
on the product.
2. Tighten all hose nuts by hand. Never
use a wrench when tightening the
nuts.
3. Open the taps completely after
making the hose connection to check
for water leaks at the connection
points. If any leaks occur, turn off the
the nut carefully after checking the
seal. To prevent water leakages and
damages caused by them, keep the
taps closed when the machine is not
in use.
EN