Table of Contents
Advertisement
Loading the Battery
Before using the camera, users must load the Lithium-ion
rechargeable battery come within the package.
1.
Insert the battery according to the correct polarity marks ( + or
-).
2.
Close the battery cover firmly.
Charge your battery
You must use the supplied AC charger or the USB cable.
The camera must be turned OFF; blinking light confirms charging, and the
light becomes constant when the charging has been completed.
(In AC charging Mode, the light will turn itself off automatically after 3~5
minutes . The full charge time is about 3 to 4 hours.)
Inserting and Removing an SD Card
expand the memory capacity by using an optional SD memory card.
You
can
1.
Insert the memory card into the slot. Please refer to the figure on
the right side.
2.
To remove an installed SD card, press the card inwards to release
it.
3.
When the card pops out, gently remove it from its slot.
4.
Recommended memory capacity: 1GB or above.
Note
•
When a memory card is fitted, videos/photos are saved
on the card rather than on the built-in memory.
•
Protecting Data on an SD Card: SD Card is read-only
when it is locked. No photos or videos can be recorded
when the SD card is locked. Make sure the lock is on
the writeable position before recording any media.
Getting Started
Writeable
7
Section 2
Write-Protected
position
Position
EN
Advertisement
Table of Contents
