Decanter Use and Care Breakage may occur if the following instructions are not followed: This decanter is designed for use with your Mr. Coffee coffeemaker and therefore must never be used on a range top or in any oven, includinq a microwave.
All manuals and user guides at all-guides.com Table Of Contents Page # Important Safeguards ......................2 Cord Set Instructions ......................2 Installation ........................3-5 Setting the Clock and Timer ....................5-6 Before Using ........................6 Brewing Coffee ........................6 Automatic Shut Off ......................
All manuals and user guides at all-guides.com 5. Read carefully the following instructions for installation. Familiarize yourself with the mounting hardware and procedure, before you begin actual installation. Installing The Coffeemaker 1. Hold the coffeemaker up to the installation site with the front face of the coffeemaker flush with the cabinet face.
All manuals and user guides at all-guides.com 14. Finish tightening the screws. 15. Secure the power cord against the cabinet bottom or rear wall by using the two Adhesive-backed cord clips. Removing The Coffeemaker Remove the glass decanter and brew funnel. After use, allow the coffeemaker to cool completely.
OFF and then to AUTO. Before Using Your Mr. Coffee Make sure your first cup of coffee is as good as can be by cleaning your Mr. Coffee coffeemaker before you use it the first time. Just follow these simple steps: 1.
(Read Caution Statement on Side Panel of Mr. Coffee Cleaner Box Before Use) 1. Fill the decanter with 4-5 cups of warm water. 2. Empty contents of one packet of MR. COFFEE CLEANER into the decanter and stir until the cleaner is completely dissolved. This will make a clear blue solution.
Avoid using chemically softened water. If Service Is Required If service is required for your Mr. Coffee machine, please consult your listing of authorized service centers packed with your brewer.
Need help?
Do you have a question about the UTC 403 Series and is the answer not in the manual?
Questions and answers