F. CABINET ITEMS
1.
Magnetic catches 111 are a push-fit in front top panel 109.
2.
To remove front top panel 109, remove both sliding table tops completely (see A.1.) and magnetic catches
111. Drill out the rivet at each end of the front slide panel using a 3mm bit. Use extreme care when drilling.
Withdraw leg top caps 108, and then remove the front top panel assembly. Refit in reverse order.
3.
Castor wheels 116 are a push-fit onto castor wheel inserts 117. The castor wheel inserts are a push-fit into
the cabinet. Remove by prising out with care.
L
E
NEON
N
SPECIFICATION
Voltage
Loading
Cord length
Pre-heat time
Finish
Dimensions (approx)
SERVICE INFORMATION
The elements used in this appliance are of the adhesive variety and cannot be removed easily. For this reason,
elements and plates are supplied as complete assemblies.
THEORETICAL WIRING DIAGRAM
TOP
ELEMENT
230 V a.c. 50 Hz
410 W (Top 110 W, Middle 110 W, Bottom 190 W)
2 m
30 minutes approx
See text
725mm W x 380mm D x 695mm H
HL6232 SERIES
MIDDLE
ELEMENT
BOTTOM
ELEMENT
PAGE 3