Advertisement
To Build the Super Set on the Front of This Package
Note: This Super Set is a Super challenge! It is a good idea to practice first with the smaller
sets described in your instruction sheets and become familiar with Darda construction
before tackling the Super Set.
1.
Connect two modular base plates using three bars.
• Slide bars half way into each of the three channels on the underside
of one of the base plates.
• Line the second base plate up so that the bars from the first base
plate slide into the empty channels of the second base plate Slide
base plates together firmly so that there are no gaps in between them.
2.
Build the tower as shown in figure 2, using 44 bars
and 26 couplers. Begin by pushing the bars into the
built-in squares on the modular base plate, and build
up from there.
• Once the tower is built, add large joiners by removing
the appropriate bar and sliding the bar into the short
channel on the underside of the large joiner. Then
replace bars with the large joiners facing in the direction
shown.
• Attach flex tracks to the large joiners as shown. Be sure
flex tracks meet in the center of the large joiners and that
there are no gaps.
• To add the three small joiners, first remove the
appropriate bars. To connect flex tracks to small joiners,
twist the flat side of the small joiner into the grooves on
the underside of the flex track. Then replace the bars.
• Add two 14" straight tracks, one 7" straight track and
flexi-curve as shown in figure 2. Use the built-in track
joiners on the base plate to connect straight track
pieces to each other, as shown. Use regular track
joiners to connect 14" to flexi curve as shown.
start
standard
car on the
14"
straight
track just
before
flexi curve
flexi
curve
7"
figure 3
small base
plate
flex track
14"
180° curve
large
joiner
48"
large
joiner
41"
small
joiners
48"
anchor this 48" to the built-in
track joiner on the base plate
3.
Turn the assembled tower so that it is facing in the
direction shown in figure 3. Complete the circuit as shown.
NOTE: It takes two cars to make it through this Super Set.
The standard car (red motor) will go through the tower,
then tap the Stop & Go car (blue motor), and the Stop &
Go car will go through the straight-away and loops.
large base plates
14"
14"
90°
curves
1.75"
7"
start Stop &
Go car here
figure 1
41"
figure 2
48"
large
joiner
large
joiner
use regular track
14"
14"
use built-in track joiners here
Attach loops and track
pieces to the large and
small base plates using
the built-in track joiners
on the base plates.
14"
14"
180° curve
flexi curve
14"
joiner here
Advertisement
