SharkNinja Operating Rocket Quick Start Manual page 2

STORAGE
Onboard Hook
Hang the handheld vacuum on the hook on the bottom of
the wand, and wrap the power cord around the cord hooks.
Brushroll/Soft Roller Access
1. To open the brushroll garage, slide both release buttons
on the floor nozzle away from you, towards the back of the
nozzle, then lift off the lid.
2. To close the brushroll garage, insert the 3 tabs on top of
lid into the 3 slots in the nozzle, then push down on both
sides of lid until it clicks securely into place. If Brushroll
Indicator Light isn't green and headlights are flashing,
check again that both sides of lid are locked in place.
Brushroll Maintenance
With the garage lid removed, carefully clear away any
debris that may be impeding the brushroll.
NOTE: If you see any hair wrapped around the brushroll, continue
cleaning, using Setting II, Carpet, on bare floors. This will allow
Zero-M® technology to remove the hair wrap and send it to the
dust cup.
For questions or to register your product, visit us online at sharkclean.com
©2019 SharkNinja Operating LLC.
Empty dust cup every time debris reaches the MAX fill line.
To remove the dust
cup from the handheld
vacuum, squeeze the
two Dust Cup Release
buttons at the same
time and pull out the
dust cup. Press the
Empty button on the
front of the dust cup.
MAINTENANCE
Lift out the Soft Roller by pulling the tab on the right
side. Clear away any debris, then slide the Soft Roller
back into place.
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the airway, then
remove any blockages.
@sharkcleaning
DUST CUP
Empty
With the dust cup
attached to the
handheld vacuum, press
the Empty button on the
front of the dust cup.
Cleaning the Soft Roller