Innohome STOVE GUARD Manual For User

What do the alarm signals mean?
The Intelligent Heat Sensor is above the range:
the alarm signal is a high-tone beep.
The Control Unit is behind the range:
the alarm signal rings similarly to a telephone.
Sound Meaning
Intelligent Heat Sensor: The pre-alarm signal is
a short beep every few emitted before the range is
seconds (pre-alarm signal) turned off.
Intelligent Heat Sensor: The Stove Guard has turned
repetitive fast 'beep, the range off.
beep, beep' (actual alarm)
Control Unit: The Stove Guard has turned
a short buzzing sound at the range off some time
5 second intervals ago.
Control Unit: The range is too hot to be
a continuous buzzing turned back on.
sound
Control Unit:
The range has been turned
a short ring and a long ring,
off due to a temporary error
alternating at 5 second or a fault in the system
intervals (automatic fault diagnosis).
Intelligent Heat Sensor The Heat Sensor has a low
(and the Control Unit):
battery.
a beep/ring once a minute
SGK430-GuideForUser-US-revF-ver1
www.innohome.com
Course of Action
If the alarm triggers during a
normal cooking situation, press
the Heat Sensor cover once during
the pre-alarm sound.
First turn all range knobs off,
then press the Intelligent Heat
Sensor cover once. (In ranges that
are operated by touch just press
the Intelligent Heat Sensor
cover once.)
First turn all range knobs off, then
press the Intelligent Heat Sensor
cover once. (In ranges that are
operated by touch just press the
Intelligent Heat Sensor cover
once.) If you cannot turn the range
back on, see question 1 in FAQ,
chapter 2 in the reference manual.
Wait until the range cools down
to a safe level. The range can be
turned on again when the Control
Unit starts to emit a short ring
every 5 seconds (see row above).
First turn all range knobs off, then
press the Heat Sensor cover once.
(In ranges that are operated by
touch just press the Sensor cover
once.) If this does not silence
the alarm, see question 3 in FAQ,
chapter 2 in the reference manual.
The Heat Sensor needs to be
replaced (see the reference
manual chapter 4). Pressing the
Heat Sensor cover delays the
alarm for 12 hours. When the
battery has run out the range can
only be used for 5 minutes at a time.
STOVE GUARD SGK 430
GUIDE FOR USER
The Stove Guard observes changing range temperatures. If the
Stove Guard detects a risk situation, it signals an alarm and turns
the range off.
When first using the Stove Guard
The Stove Guard is ready for use immediately after installation. However, at the
beginning, it may start to signal during normal cooking. This is because the
Stove Guard gradually adjusts to different cooking styles.
When the Stove Guard settings are ready (usually after around 1 – 3 alarms),
the alarms will no longer trigger during normal cooking.
Pressing the Intelligent Heat Sensor cover during the pre-alarm signal
( ) stops the alarm and the Stove Guard adjusts its
sensitivity automatically.