Sound; Sound Effect; Balance; Smart Volume - TCL 43P1US Operation Manual

- Gamma: Sets the shape of the Gamma curve. Use
lower Gamma values for bright ambient lighting, and
higher values when it is dark.
- Color Temperature: Adjusts the color temperature
of the picture. Press ◄/► to select the color settings:
Cool for a more blue palette of picture colors; Normal
and Warm for a more red palette of picture colors.
- Noise Reduction: Improves the quality of the picture
in the case of poor reception. Press ◄/► to select
Off, Low, Medium, or High.
- Motion Enhance: Press ◄/► to select Off, Low,
Medium, or High.

Sound

Sound

Sound Effect

Standard

Balance

0

Smart Volume

Off

SPDIF Mode

PCM

SPDIF Delay

0

Sound Type

...
This menu allows you to adjust each option to obtain the
best sound settings to optimize audio output.
Press SETTING to display the main menu and select
Sound, then press OK to confirm. The Sound options
are as follows:
Sound Effect
Press OK to enter. Press ▲/▼ to select Sound Effect
among Standard, Movie, News, Music and User.
Note: When Sound Effect is set to User, five more
Sound options (Sound 120 Hz, Sound 500 Hz, Sound
1.5 KHz, Sound 5 KHz, and Sound 10 KHz) will be
displayed, which enable you to adjust the frequency
levels desired.
Balance
Press ◄/► to balance the sound between the left and
right speakers.
Smart Volume
To keep the same sound level for all channels, set
Smart Volume to On.
SPDIF Mode
This option is used to control the type of audio stream
System Settings Menu
sent to the Digital Audio Output (SPDIF) socket. Press
▲/▼ to select Auto or PCM.
SPDIF Delay
This option is used to synchronize the sound with the
picture. If the sound is slower/quicker than the action
of the picture, you can press ◄/► to turn down/up the
numerical value.
Sound Type
Press ▲/▼ to select Stereo, Mono, or SAP.
Note: The options available may vary depending on the
channel's signal.

Channel

Channel

Channel Scan

Channel Favorite
Channel Edit
When you first used your TV you will have to set up your
TV for DTV/ATV channels using the Initial Setup menu.
If you did not do this or if your setup has changed, you
can do this from this menu.
Press SETTING to display the main menu and select
Channel, then press OK to confirm. The Channel
options are as follows:
Channel Scan
This allows you to scan for all available analog and
digital channels.
The options are as follows:
- Auto Search:
1. Select Channel > Channel Scan > Auto Search,
and then press OK to enter.
2. Press OK to start the channel scan. The search
process may take a few minutes. During the
process, you can press SETTING or EXIT to abort
halfway.
3. Once the scan ends, the TV automatically goes to
the first channel searched, and all channels are
arranged in a preset order. You can press CH LIST
to display the channel list.
- DTV Manual Search
This allows you to scan for all available digital channels.
18
...
...
...