Tx Deviation Adjustment (Dcs); Tx Deviation Adjustment (Ctcss); Exit From The Alignment Mode - Vertex Standard HX400 Alignment Manual

to 4.2 kHz (+0 kHz/–0.1 kHz).
Press and hold the [H/L] key for 2 seconds to save the new setting at the band center.
Press the [CLR] key to exit from this alignment item.
TX Deviation Adjustment (DCS)
Connect the wattmeter and dummy load to the antenna jack, then connect the deviation
meter to the antenna jack through the VHF sampling coupler.
Press the [ ] or [ ] key to select the display to "DCS".
Press the [SQL] key, then press the [H/L] key to enable adjustment of the TX Deviation
(DCS).
Press the PTT key to enable the transmitter and to output a DCS tone, press the [ ] or [ ]
key to adjust the deviation to 0.6 kHz (±0.1 kHz).
Press and hold the [H/L] key for 2 seconds to save the new setting.
Press the [CLR] key to exit from this alignment item.
TX Deviation Adjustment (CTCSS)
Connect the wattmeter and dummy load to the antenna jack, then connect the deviation
meter to the antenna jack through the VHF sampling coupler.
Press the [ ] or [ ] key to select the display to "CTCSS".
Press the [SQL] key, then press the [H/L] key to enable adjustment of the TX Deviation
(CTCSS).
Press the PTT key to enable the transmitter and to output a CTCSS tone, press the [ ] or
[ ] key to adjust the deviation to 0.7 kHz (±0.1 kHz).
Press and hold the [H/L] key for 2 seconds to save the new setting.
Press the [CLR] key to exit from this alignment item.
Exit from the Alignment mode
To exit from the Alignment mode, turn the transceiver off.
7 Vertex Standard Co.,Ltd.
FCC ID:K6630393X20
IC: 511B-30393X20
Alignment