BAUKER NL360-1 Manual page 14

Technical Data
Power
Working time
Laser wave length
Laser power
Laser line width
Working range
Accuracy
Leveling time
Leveling range
Working temperature
Dimensions (length x width x height)
The safe use of this product requires an understanding of the information
on the tool and in this nstruction manual, as well as knowledge of the
project you are attempting. Before use of this product, familiarize yourself
with all operating features and safety rules.
Power switch
Push the power switch up to turn the self-levelling laser level on, and
The battery compartment holds four "AA" batteries.
1. Push the latch to open the battery cover.
2. Inser four new " AA" alkaline batteries,following the polarity (+/-) as
indicated on the pole plate.
3. Securely close the cover.
25
6V,4-AA Battery
＞15h
635nm
Class 2,＜1mw
100 LUX,3mm/5m
10m
±0.5mm/m
≤4s
≥4s
0-40℃
94.7x65.2 x105.8mm
NOTE:
• Always turn off the tool before installing or replacing the batteries.
• Remove the batteries from the tool when not using it for extended peri-
ods.
• The AA batteries should match each other in brand and type.
• Do not mix old and new batteries.
• Remove depleted batteries immediately, and dispose of them according
to the laws and regulations governing your community.
Your self-levelling 360 ° line laser level has three laser-projection
button until you reach the desired projection mode. This laser tool
defaults to the cross-hair pattern mode when it is turned on. To choose a
projection mode, press the mode button:
1. Press the button once to select the cross-hair pattern (horizontal and
vertical)
2. Press the button twice to select the horizontal laser line.
3. Press the button three times to select the vertical laser line.
Using your self-levelling 360°line laser level
Your self-levelling 360°line laser level has two working modes
Self-levelling mode and Lock (manual) mode.
Self-levelling mode
In this mode, the tool will level itself if it is within ±4° of horizontal.
that is within ±4° of horizontal.
2. Turn the tool on by sliding the power switch to the up position.
The self-levelling 360°line laser level will automatically level within 5
seconds.The LED indicator will shine green.
360° LASER LINE
26