Parts Identification - HoMedics ELLE MACPHERSON THE BODY Instruction Manual

IB-IPL100GB-0313-01_Layout 1 18/06/2013 15:01 Page 4

PARTS IDENTIFICATION

The IPL consists of the following main components: Base unit, applicator and AC cord.
BASE UNIT AND APPLICATOR
Energy Level
Selection Buttons
Standby Button
Main Power Button
BASE UNIT
Main power button
Standby button
Energy level selection button – Press "-" or "+" to select energy level
6 Energy levels lights – Light up green when energy level is selected
Replace cartridge light – will stay on when the cartridge needs replacing
APPLICATOR
Trigger Button
Indicator Light
Two trigger buttons (flash pulse activation) are located on each side of the applicator hand piece (see
diagram on right). Either one of the trigger buttons will activate the flash lamp. The two buttons are
implemented for right and left handed convenience only.
The replaceable lamp cartridge is located inside the applicator's inner body.
The indicator light is located in the top middle of the applicator head and lights green/red as follows:
No light - Pulse is not ready.
Green light on – Pulse is ready.
Red light on – Pulse is blocked due to lack of full skin contact and/or incompatible skin tone (high Fitzpatrick
level see user instruction section on page 10).
Red LED on applicator comes on and the device switches itself off – Cartridge is not properly connected
when the device is turned on.
4
Replace
Cartridge Light
6 Energy Level
Lights
Treatment area