Jarv JRV-SBD1400HR User Manual

Device Overview

How to wear your Elite+ HR Fitness Band?

1
Attach your Elite +HR Fitness Band
to your wrist
Put on the wristband with the screen facing up and the band
wrapped around your wrist. Align the METAL CLASP along
the band to find the hole that best fits your wrist size.
*Please make sure to fasten with the METAL CLASP and not
the smaller plastic clasp.
3

Charge your Elite +HR Fitness Band

To charge your Elite +HR Fitness Band, place it in the charging
box at the other end of the USB cable. Close the box afterwards,
and make sure the Elite +HR Fitness Band is securely covered
and that the charging contacts are properly aligned. Plug the
USB connector to either a PC or power adapter to start charging.
Initial charging time is approximately 2 hours.
For warranty information, troubleshooting or other customer service needs please visit www.jarvmobile.com
Register your product online at www.jarvmobile.com to receive a free 6 month warranty extension
Jarv Elite +HR Fitness Band and Smart Watch
2
Fasten your Elite +HR Fitness Band
with the metal clasp
Press down on the METAL CLASP into the holes of the wristband
until you hear a click indicating that the band is securely fastened
4

Change the wristband

Spread open both bands with the screen facing up, and press down
1.
the screen with your thumb until the core comes off the wristband.
Insert the core with screen facing up into the notch from below the
2.
wristband. Button up the clasp on the side of the band with 2 holes.
Please note that the charging contact should be near the clasp.
*Failure to follow the instruction above might cause damage to the device
EN
User Manual