Jarv Advantage HR Quick Start Manual

Smart watch + tracker + heart rate

Advertisement

I. HOW TO CHARGE YOUR JARV ADVANTAGE HR SMART WATCH / FITNESS TRACKER
Plug the enclosed USB Charging cable directly into your PC USB port, USB wall adaptor (not included) or any similar
1
electrical source. Charge fully before use. Initial charging time is approximately 2 hours.
Place the watch face up within the charging cradle so that the charging connectors are properly aligned. It is very important
2
that the charging connectors behind the watch face and inside the charging cradle are properly aligned to each other in
order for the watch to successfully charge.
You should see a battery meter symbol appear on the watch's display. If you do not see the battery meter appear at rst,
3
please make sure the connectors are properly aligned and press down on the watch face to ensure contact until the battery
meter symbol appears.
Once the battery meter is displayed, hold the watch and charger steady and carefully snap the charger clasp close.
4
Put the watch/charger down on a stable at surface. The battery meter will disappear after a couple of seconds, to save
5
energy, but the watch is still charging. If you pick the watch/charger up, the battery meter will reappear on the display.
Once charging is complete a full battery meter will be displayed on the watch's display when picked up.
1
II. HOW TO MEASURE YOUR HEART RATE CORRECTLY ON THE JARV ADVANTAGE HR SMART WATCH /
FITNESS TRACKER
1
a) On your mobile device, log in to the
i-GotU Life app
b) Select " Workout "
c) Select " Optical Sensor " under the "Heart
Rate Sensor" sub menu
Jarv Advantage HR Smart Watch + Tracker + Heart Rate
2
*IMPORTANT:
Make sure connectors are properly aligned and press down
3
2
When using any of the features under the "Heart Rate
Sensor" sub menu, please refer to the instructions on "How
to Wear your Jarv Advantage HR Smart Watch" and select
the mode you wish to use from the "Optical Sensor" option.
For best results, select "Sports Mode" -If you select "Sport/Daily
Mode" your battery will be depleted within 7 hours
4
5
Wearing your Advantage HR Smart Watch

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Advantage HR and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Jarv Advantage HR

  • Page 1 Once charging is complete a full battery meter will be displayed on the watch’s display when picked up. *IMPORTANT: Make sure connectors are properly aligned and press down II. HOW TO MEASURE YOUR HEART RATE CORRECTLY ON THE JARV ADVANTAGE HR SMART WATCH / FITNESS TRACKER a) On your mobile device, log in to the When using any of the features under the “Heart Rate...
  • Page 2 Advantage HR is worn as tightly as possible without any discomfort. STEP 4: Make sure your Jarv Advantage HR is set to Sports Mode. After about ten seconds, you will see your heart rate reading. If the heart rate reading is too high or too low, please switch to a di erent mode, and then switch back to Sports mode to scan the heart rate again.

Table of Contents