Download Print this page

Led Battery Power And Charging Indicators - Shark WANDVAC SYSTEM WV361UK Series Instructions Manual

Advertisement

1. Insert Wand into Nozzle.
2. Insert Handheld Vacuum into wand.
For proper operation, ensure all components are
completely connected and clicked into place.
Handheld
Vacuum
2.
Wand
1.
Floor
Nozzle
NOTE: Your vacuum's model and serial numbers can be
found on the QR code label on the bottom of the back of
the handheld vacuum.
6
s h a r kc l e a n . c o . u k
ASSEMBLY
3. Make sure the Dock Plate is facing upright. Slide
the Charging Post into the slot on the back of
the dock until it clicks into place.
4. Place the dock on the floor near a power socket.
Plug the Wall Charger into the socket, then
connect the cord to the port on the back of the
charging post.
5. Store Duster Crevice on the mount on the dock
plate.
NOTE: Once the charging post is installed, it can't be
removed.
3.
Charging
Post
4.
Assembled
Dock
Space for spare
battery located here
5.
Accessory
Storage
Prior to first use, charge the battery completely. A full charge takes approximately 3 hours.
Visit Sharkclean.co.uk online or review the included Quick Start Guide.
Charger
Dock
Plate
This product uses a Li-ion rechargeable and recyclable battery. When the battery no longer holds a charge,
it should be removed from the vacuum and recycled. DO NOT incinerate or compost the battery. When your
Lithium ION Power Pack Battery needs to be replaced, dispose of it or recycle it in accordance with local
regulations. In some areas, it is illegal to place spent lithium-ion batteries in the bin or in a municipal solid
waste stream. Return spent power packs to an authorised recycling center or to retailer for recycling.
To order spare
Contact your local recycling center for information on where to drop off the spent power pack.
batteries or
accessories visit
sharkclean.co.uk
NOTE: A complete charge takes approximately 3 hours. The Li-ion battery will naturally decrease in capacity over time from
the 100% capacity of a new battery.
LI-ION BATTERY
RUNTIMES PER FULLY CHARGED BATTERY

LED BATTERY POWER AND CHARGING INDICATORS

Charging
Low
Mid
Charge
Charge
NOTE: Full charge takes approximately 3 hours.
LEDs will shut off 10minutes after achieving full charge.
In Use
Full
Mid
Charge
Charge
RECYCLING THE LI-ION BATTERY
Nearly
Full
Full
Charge
Low
Nearly
No
Boost
Charge
Empty
Charge
Mode
7
s h a r kc l e a n . c o . u k

Advertisement

loading

This manual is also suitable for:

Wandvac system wv362uk series