Tools Needed And Loose Parts; Assembly - KNOVA KN 7053 Manual

TOOLS NEEDED AND LOOSE PARTS

The following tools
Adjustable wrench
(not included or
drawn to scale)
are needed for
assembly and
alignment:
Fig. 3
A. Hex head bolt
H. Work rest, left
B. Washer
I. Work rest knob
C. Clamp bracket
J. Work rest, right
D. Spark deflector K. Carriage bolt
E. Flat washer
L. Shield rod, right
F. Lock washer
M. Shield rod, left
G. Screw
N. Spark shield assembly

ASSEMBLY

UNPACKING
This product requires assembly.
• Carefully remove the tool and any accessories from
the box. Make sure that all items listed in the Loose
Parts are included.
WARNING
Do not use this product if any parts on the
Loose Parts List are already assembled to your product
when you unpack it. Parts on this list are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may have
been improperly assembled could result in serious
personal injury.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
• Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
• If any parts are damaged or missing, please call
01-800 70 56682 for assistance.
WARNING If any parts are damaged or missing do not
operate this product until the parts are replaced. Use of
this product with damaged or missing parts could result
in serious personal injury.
WARNING
Do not attempt to modify this tool or
create accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
13 mm wrench
Phillips screwdriver
I
A
G
D
F
E
K
B
M
L
WARNING
Always spin the wheel by hand before
turning on the grinder to make sure the spark
deflector doesn't hit the grinding wheel.
MOUNTING GRINDER TO WORKBENCH
See Figure 5.
The bench grinder must be mounted to a firm supporting
surface such as a workbench or leg stand. Four bolt holes
have been provided in the tool's base for this purpose.
Each of the four mounting holes should be bolted
securely using machine bolts, lock washers, and hex nuts
(not included). Bolts should be of sufficient length to
accommodate the saw base, lock
washers, hex nuts, and the thickness
of the workbench. Tighten
all four bolts
securely.
Fig. 5
Carefully check the workbench after mounting to make
sure that no movement can occur during use.
If any tipping, sliding, or walking is noted, secure
the workbench to the floor before operating.
5
J
C
H
N
Fig. 4
Bolt
Washers
Lock
washer
Hex nut