Advertisement
4
Turn the focus ring to sharpen the image.
5
If your image looks like
one side of the screen at an angle. Place the projector directly in front of
the center of the screen, facing the screen squarely. Or use the horizontal
keystone slider on the projector to correct it.
6
Your projector automatically adjusts images that look like
but if necessary you can press the
correct this.
Using the remote control
Make sure the batteries are installed as shown (two AA batteries).
Turn projector on
Switch between
2D and 3D
Access projector
menus
For more information on using the remote control, see the User's Guide on your
projector CD.
Viewing 3D images
To view 3D content, you must first connect a 3D-compatible video device to
one of the HDMI ports on your projector. You will also need a pair of Epson or
Eson-compatible 3D RF active shutter glasses.
1
Turn on and begin playback on the 3D-compatible video device.
2
Press the
button on the projector remote control, if necessary.
or
, you've placed the projector off to
or
or
buttons on the projector to
Turn projector off
Choose which source
to display
Navigate projector
menus
Turn off projector
display
3
Slide the power switch on your 3D glasses to the On position.
Note: If the glasses don't automatically display 3D content, you may
need to pair them with the projector. Move the glasses within 10 feet
(3 m) of the projector, then press and hold the Pairing button on the
3D glasses for at least 3 seconds. The status light on the glasses will
alternately flash green and red, then remain green for 10 seconds if
pairing is successful.
You can also automatically convert 2D HDMI content to 3D. To enable the
2D-to-3D Conversion option, press the Menu button on the projector or
remote control. Select Signal and press Enter, then select 3D Setup and
,
press Enter. Select 2D-to-3D Conversion and press Enter. Select the Weak,
Medium, or Strong setting, then press Enter.
See the online User's Guide for more information on adjusting 3D images.
Troubleshooting
If you see a blank screen or the No signal message after turning on your
video device or computer, check the following:
•
Make sure the power light on the projector is blue and not flashing.
•
Press the Source buttons on the remote control or the
the projector to switch to the correct image source, if necessary.
•
If you're using a Windows
keyboard that lets you display on an external monitor. It may be labeled
CRT/LCD or have an icon such as
Fn key while pressing it (such as Fn + F7). Wait a moment for the display
to appear.
•
If you're using a Mac laptop, open System Preferences and select
Displays. Select the VGA Display or Color LCD option if necessary,
then click the Arrange or Arrangement tab, and select the Mirror
Displays checkbox.
If 3D images aren't displaying properly, check the following:
•
Press the
button on the remote control to switch to 3D viewing
mode, if necessary.
•
Make sure that you are within the 3D viewing range. See "Choose a
location" or the User's Guide on your projector CD for more information.
•
Check that your 3D glasses have not entered standby mode. Slide the
power switch on the 3D glasses into the Off position, then back to the
On position.
•
Press the Menu button on your remote control, select the Signal menu,
then 3D Setup, then select 3D Format. Make sure that the Auto
option is selected.
•
Check that your video device and media are both 3D-compatible.
Refer to the documentation that came with your video device for
more information.
laptop, press the function key on your
®
. You may have to hold down the
button on
Advertisement
